tag:blogger.com,1999:blog-6603759559639831257.post2119278631328880764..comments2022-08-18T22:14:01.104-07:00Comments on SCAMP #243: Dynel, Cleats, and Building JigWoodnMetalGuyhttp://www.blogger.com/profile/07650735119777059767noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-6603759559639831257.post-71304375780853584592016-02-08T14:04:12.807-08:002016-02-08T14:04:12.807-08:00George - the notches are there so that when the ce...George - the notches are there so that when the centerboard case gets inserted in the slot it can protrude a bit (1/4" or so). It then gets trimmed flush later on when you turn the hull over.<br /><br />I'm glad you're enjoying the blog, I hope you find lots of useful things here. I do have a few more entries to make from the final stages when I was just building and not blogging. I hope to get those done sometime...WoodnMetalGuyhttps://www.blogger.com/profile/07650735119777059767noreply@blogger.comtag:blogger.com,1999:blog-6603759559639831257.post-33162711168173618152016-02-08T13:24:05.601-08:002016-02-08T13:24:05.601-08:00BTW - your website is full of details which I wil...BTW - your website is full of details which I will refer to during my build probably. You have done a very nice job on the blog and, most of all, on the boat itself. Kudos.<br />George C.Anonymoushttps://www.blogger.com/profile/09514320615897135434noreply@blogger.comtag:blogger.com,1999:blog-6603759559639831257.post-19369846566547751052016-02-08T13:16:24.585-08:002016-02-08T13:16:24.585-08:00Oh - I see how that works now - thanks.
I'm j...Oh - I see how that works now - thanks. <br />I'm just at the jig build and find a big lack of info on it in the plans and instructions unless you are building the kit so I'm looking at other builders' jigs. They don't all have those supports. Also don't see any reference in the plans or instructions so this is good info to me. I notice that those two supports are notched a bit below the side of the jig?<br />Thanks - GeorgeAnonymoushttps://www.blogger.com/profile/09514320615897135434noreply@blogger.comtag:blogger.com,1999:blog-6603759559639831257.post-58778014976626833442016-02-08T07:20:16.362-08:002016-02-08T07:20:16.362-08:00George - those two are there to support the plywoo...George - those two are there to support the plywood on the outside of the centerboard slot - you can see them through the slot in the last photo. Since the other side does not have the slot, it is stiff enough to not need those supports.WoodnMetalGuyhttps://www.blogger.com/profile/07650735119777059767noreply@blogger.comtag:blogger.com,1999:blog-6603759559639831257.post-82406933013237431752016-02-07T08:58:04.915-08:002016-02-07T08:58:04.915-08:00Why do two of lateral supports only go halfway acr...Why do two of lateral supports only go halfway across the jig box?Anonymoushttps://www.blogger.com/profile/09514320615897135434noreply@blogger.com